Dear customers,

EXP Tech will be closed from 14.12.2020 to 04.01.2021 for the Christmas Holidays. Last shipping day in 2020 is 11.12.2020. Please plan ahead.

Merry Chrsitmas and happy new year!

Yours sincerely

Your EXP-Tech team


Pololu DRV8880 Stepper Motor Driver Carrier

€7.26 *

Prices incl. VAT plus shipping costs

Ready to ship today,
Delivery time appr. 1-3 workdays

Order within the next 19 hours and 9 minutes so the order will be shipped tomorrow .
  • Pololu
  • EXP-R25-576
  • 2971
  • 14
  • US
  • 85423190
  • 0.001
This product is a carrier board or breakout board for TI’s DRV8880 low-voltage stepper... more

This product is a carrier board or breakout board for TI’s DRV8880 low-voltage stepper motor driver; we therefore recommend careful reading of the DRV8880 datasheet (2MB pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 1.6 A output current per coil (see the Power Dissipation Considerations section below for more information). Here are some of the driver’s key features:

  • Simple step and direction control interface
  • Six different step resolutions: full-step, half-step, non-circular half-step, 1/4-step, 1/8-step, and 1/16-step
  • Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
  • Digital inputs for dynamically scaling the current limit to 25%, 50%, 75%, or 100% of the limit set by the potentiometer, which lets you reduce power consumption in situations where full speed or torque is not required
  • Ten different decay mode options:
    • AutoTune (enabled by default): automatically selects the decay mode each PWM cycle for optimal current regulation performance and to compensate for motor variation and aging effects
    • Fixed decay modes: nine different combinations of mixed, fast, and slow decay on increasing and decreasing steps
  • 6.5 V to 45 V supply voltage range
  • Built-in regulator (no external logic voltage supply needed)
  • Can interface directly with 3.3 V and 5 V systems
  • Over-temperature thermal shutdown, over-current shutdown, short circuit protection, and under-voltage lockout
  • 4-layer, 2 oz copper PCB for improved heat dissipation
  • Exposed solderable ground pad below the driver IC on the bottom of the PCB
  • Module size, pinout, and interface match those of our A4988 stepper motor driver carriers in most respects (see the bottom of this page for more information)

This product ships with all surface-mount components—including the DRV8880 driver IC—installed as shown in the product picture.

Documents:

Viewed