Tic T834 Steppermotor Controller with Connector

The Tic T834 USB Multi-Interface Stepper Motor Controller makes basic control of a stepper motor easy, with quick configuration over USB using our free software. The controller supports six control interfaces: USB, TTL serial, I²C, analog voltage (potentiometer), quadrature encoder, and hobby radio control (RC). This version incorporates a TI DRV8834 driver and male headers and terminal blocks are soldered. It can operate from 2.5 V to 10.8 V and can deliver up to approximately 1.5 A per phase without a heat sink or forced air flow (or 2 A max with sufficient additional cooling).

Features:

• Open-loop speed or position control of one bipolar stepper motor
• A variety of control interfaces
• Acceleration and deceleration limiting
• Maximum stepper speed: 50,000 steps per second
• Very slow speeds down to 1 step every 200 seconds (or 1 step every 1428 seconds with reduced resolution).
• Six different microstep resolutions: full step, half step, 1/4 step, 1/8 step, 1/16 step, and 1/32 step
• Digitally adjustable current limit
• Optional safety controls to avoid unexpectedly powering the motor
• Input calibration (learning) and adjustable scaling degree for analog and RC signals
• 5 V regulator (no external logic voltage supply needed)
• Optional kill switch inputs
• Connects to a computer through USB via a USB A to Micro-B cable (not included)
• Free configuration software available for Windows, Linux, and macOS
• Comprehensive user?s guide

Specs:

• Motor driver: DRV8834
• Control interface: USB; non-inverted TTL serial; I²C; RC servo pulses; analog voltage; quadrature encoder
• Minimum operating voltage: 2.5 V
• Maximum operating voltage: 10.8 V
• Continuous current per phase: 1.5 A
• Maximum current per phase: 2 A
• Maximum step rate: 50000 PPS
• Microstep resolutions:full, 1/2, 1/4, 1/8, 1/16, and 1/32
• Reverse voltage protection?: Y
• Header pins soldered: Y

Documents:

• Tic Stepper Motor Controller User's Guide