STSPIN820 Stepper Motor Driver Carrier

This product is a carrier board or breakout board for the STSPIN820 stepper motor driver from STMicroelectronics. This stepper motor driver offers microstep resolutions down to 1/256 of a step, and it lets you control one bipolar stepper motor at up to approximately 0.9 A per phase continuously without a heat sink or forced air flow

Key Features:

• Simple step and direction control interface
• Eight different step resolutions down to 256 microsteps: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, 1/32-step, 1/128-step, and 1/256-step
• Adjustable current control lets you set the maximum current output, which lets you use voltages above your stepper motor?s rated voltage to achieve higher step rates
• Motor supply voltage: 7 V to 45 V
• Can deliver 0.9 A per phase continuously without additional cooling
• Can interface directly with 3.3 V and 5 V systems
• Over-temperature thermal shutdown, over-current shutdown, and short circuit protection
• 4-layer, 2 oz copper PCB for improved heat dissipation
• Exposed solderable ground pad below the driver IC on the bottom of the PCB
• Module size, pinout, and interface match those of Pololu A4988 stepper motor driver carriers in most respects

Specifications:

• Motor driver: STSPIN820
• Minimum operating voltage: 7 V
• Maximum operating voltage: 45 V
• Continuous current per phase: 0.9 A
• Maximum current per phase: 1.5 A
• Minimum logic voltage: 2 V
• Maximum logic voltage: 5.5 V
• Microstep resolutions: full, 1/2, 1/4, 1/8, 1/16, 1/32, 1/128, 1/256
• Current limit control: potentiometer
• Reverse voltage protection?: N
• Header pins soldered?: N