This website uses cookies, which are necessary for the technical operation of the website and are always set. Other cookies, which increase the comfort when using this website, are used for direct advertising or to facilitate interaction with other websites and social networks, are only set with your consent.
Configuration
Technically required
These cookies are necessary for the basic functions of the shop.
"Allow all cookies" cookie
"Decline all cookies" cookie
CSRF token
Cookie preferences
Currency change
Customer recognition
Customer-specific caching
Individual prices
Selected shop
Session
Comfort functions
These cookies are used to make the shopping experience even more appealing, for example for the recognition of the visitor.
The Tic T500 USB Multi-Interface Stepper Motor Controller makes basic control of a stepper motor easy, with quick configuration over USB using our free software. The controller supports six control interfaces: USB, TTL serial, I²C, analog voltage (potentiometer), quadrature encoder, and hobby radio control (RC). It can operate from 4.5 V to 35 V and can deliver up to approximately 1.5 A per phase without a heat sink or forced air flow (or 2.5 A max with sufficient additional cooling).
Features and specifications:
Open-loop speed or position control of one bipolar stepper motor
USB for direct connection to a computer
TTL serial operating at 5 V for use with a microcontroller
I²C for use with a microcontroller
RC hobby servo pulses for use in an RC system
Analog voltage for use with a potentiometer or analog joystick
Quadrature encoder input for use with a rotary encoder dial, allowing full rotation without limits (not for position feedback)
STEP/DIR inputs for compatibility with existing stepper motor control firmware
Acceleration and deceleration limiting
Maximum stepper speed: 50,000 steps per second
Very slow speeds down to 1 step every 200 seconds (or 1 step every 1428 seconds with reduced resolution).
supports full step, half step, 1/4 step, 1/8 step
Digitally adjustable current limit
Optional safety controls to avoid unexpectedly powering the motor
Input calibration (learning) and adjustable scaling degree for analog and RC signals
5 V regulator (no external logic voltage supply needed)
Optional kill switch inputs
Connects to a computer through USB via a USB A to Micro-B cable (not included)
Free configuration software available for Windows, Linux, and macOS
This website uses cookies, which are necessary for the technical operation of the website and are always set. Other cookies, which increase the usability of this website, serve for direct advertising or simplify interaction with other websites and social networks, will only be used with your consent. More information
