Article successfully added.

Pololu TB67S279FTG Stepper Motor Driver Compact Carrier

€7.97 *

Prices incl. VAT plus shipping costs

Ready to ship today,
Delivery time appr. 1-3 workdays

  • Pololu
  • EXP-R25-1276
  • 3098
  • 4
  • US
  • 85423190
  • 0.005
P Secure bonuspoints now
This breakout board for Toshiba’s TB67S279FTG microstepping bipoloar stepper motor driver is... more

This breakout board for Toshiba’s TB67S279FTG microstepping bipoloar stepper motor driver is arranged in the popular 16-pin Pololu form factor, making it a more compact alternative to the full breakout. It features adjustable current limiting and seven microstep resolutions (down to 1/32-step). Additionally, it dynamically selects an optimal decay mode by monitoring the actual motor current, and it can automatically reduce the driving current below the full amount when the motor is lightly loaded to minimize power and heat. The TB67S279FTG has a wide operating voltage range of 10 V to 47 V, and it can deliver approximately 1.1 A per phase continuously without a heat sink or forced air flow (up to 2 A peak). It features built-in protection against under-voltage, over-current, and over-temperature conditions.

Features:

  • Simple step and direction control interface
  • Seven different step modes: full-step, non-circular half-step, circular half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
  • Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
  • Advanced Dynamic Mixed Decay (ADMD) dynamically switches between slow and fast decay modes by monitoring the state of current decay (not according to fixed timing)
  • Configurable Active Gain Control (AGC) can be enabled to automatically reduce drive current by up to 40% to minimize power consumption and heat generation when maximum torque is not needed.
  • Motor supply voltage: 10 V to 47 V
  • Maximum continuous current per phase without additional cooling: 1.1 A (2 A peak)
  • Built-in regulator (no external logic voltage supply needed)
  • Can interface directly with 3.3 V and 5 V systems
  • Under-voltage lockout and protection against over-current/short-circuit and over-temperature
  • Open-load detection
  • Active-low error outputs indicate over-current, over-temperature, or open-load condition
  • Compact size 1.52 x 2cm
  • 4-layer, 2 oz copper PCB for improved heat dissipation
  • Exposed solderable ground pad below the driver IC on the bottom of the PCB

Specifications:

  • Motor driver: TB67S279FTG
  • Minimum operating voltage: 10 V
  • Maximum operating voltage: 47 V
  • Continuous current per phase: 1.1 A
  • Maximum current per phase: 2 A
  • Minimum logic voltage: 2 V
  • Maximum logic voltage: 5.5 V
  • Microstep resolutions: full, non-circular 1/2, 1/2, 1/4, 1/8, 1/16, 1/32
  • Current limit control: potentiometer
  • Reverse voltage protection?: N
  • Header pins soldered?: N
  • Size:1.52 x 2cm
  • Weight:1.5 g
Viewed