Tic T249 USB Multi-Interface Stepper Motor Control

€59.95 *

Prices plus VAT plus shipping costs

19 Stück ready for shipment

  • Pololu
  • EXP-R25-1294
  • 3139
  • US
  • 85423190
  • 0.005
The Tic T249 USB Multi-Interface Stepper Motor Controller makes basic control of a stepper motor... more

The Tic T249 USB Multi-Interface Stepper Motor Controller makes basic control of a stepper motor easy, with quick configuration over USB using our free software. The controller supports six control interfaces: USB, TTL serial, I²C, analog voltage (potentiometer), quadrature encoder, and hobby radio control (RC). This version incorporates a Toshiba TB67S249FTG driver with innovative and unique features that include Automatic Gain Control, and male headers and terminal blocks are included but not soldered. It can operate from 10 V to 47 V and can deliver up to approximately 1.8 A per phase without a heat sink or forced air flow (or 4.5 A max with sufficient additional cooling).

Features:

  • Open-loop speed or position control of one bipolar stepper motor
  • USB for direct connection to a computer
  • TTL serial operating at 5 V for use with a microcontroller
  • I²C for use with a microcontroller
  • RC hobby servo pulses for use in an RC system
  • Analog voltage for use with a potentiometer or analog joystick
  • Quadrature encoder input for use with a rotary encoder dial, allowing full rotation without limits (not for position feedback)
  • STEP/DIR inputs for compatibility with existing stepper motor control firmware
  • Acceleration and deceleration limiting
  • Maximum stepper speed: 50,000 steps per second
  • Very slow speeds down to 1 step every 200 seconds (or 1 step every 1428 seconds with reduced resolution)
  • support full step, half step, 1/4 step, 1/8 step, 1/16 step, and 1/32 step
  • Digitally adjustable current limit
  • Optional safety controls to avoid unexpectedly powering the motor
  • Input calibration (learning) and adjustable scaling degree for analog and RC signals
  • 5 V regulator (no external logic voltage supply needed)
  • Optional limit switch inputs with homing capabilities
  • Optional kill switch inputs
  • STEP/DIR outputs for controlling external stepper motor drivers
  • Connects to a computer through USB via a USB A to Micro-B cable (not included)
  • Free configuration software available for Windows, Linux, and macOS

Specifications:

  • Motor driver: TB67S249FTG
  • Control interface: USB; non-inverted TTL serial; I²C; RC servo pulses; analog voltage; quadrature encoder
  • Minimum operating voltage: 10 V
  • Maximum operating voltage: 47 V
  • Continuous current per phase: 1.8 A
  • Maximum current per phase: 4.5 A
  • Maximum step rate: 50000 PPS
  • Microstep resolutions: full, non-circular 1/2, circular 1/2, 1/4, 1/8, 1/16, and 1/32
  • Reverse voltage protection?: Y
  • Connectors soldered?: N
Viewed