Teensy 3.2 Breakout

This is a breakout for the Teensy 3 development board by PJRC. This breakout is fully compatible with the Teensy 3.0, the Teensy 3.1, and the Teensy 3.2, the only notable difference being that the RESET pin on the 3.0 has become pin A14 on later versions. Included are all the pin headers you need to assemble it, as well as two machine screws for more permanent mounting.

This breakout board can also be used with the Teensy LC, although it's arguably somewhat less useful since there are only 7 extra pins (instead of 23) to break out, and you'll have to ignore (and translate) the printed pin names. Take a look at this post on the PJRC forum for more information and a chart.

Included Parts:

• (1×) Teensy 3.2 Breakout (Revision A) bare printed circuit board
• (3×) 40-pin (1 row × 40 pins) through-hole male header
• (1×) 14-pin (2 rows × 7 pins) surface-mount male header
• (2×) #6-32 × 3/16" stainless steel pan-head machine screw
• (1×) gold-plated pogo pin (spring-loaded connector)
• Mill-Max Manufacturing 0906-1-15-20-75-14-11-0
• Digi-Key part number ED8181-ND
• (1×) 32.768 kHz tuning fork crystal
• Citizen CFS-20632768DZFB
• Digi-Key part number 300-1002-ND

Detailed Specs:

• Grid Spacing — 0.1 in (2.54 mm)
• Board Dimensions — 2.4 in (60.96 mm) × 0.9 in (22.86 mm)
• Board Surface Area — 2.16 in² (13.94 cm²)
• Number of Breakout Pins — 48 pins (2 rows × 24 pins)
• Number of Mounting Holes — 2 holes
• Mounting Hole Distance — 2.0 in (50.8 mm)
• Mounting Hole Diameter — 0.15 in (3.81 mm)
• Mounting Hole Pad Diameter — 0.27 in (6.858 mm)

Recommended Tools:

• Soldering iron
• Solder
• Flux
• Breadboard
• Diagonal cutters
• Needle-nose pliers
• Masking tape
• Prying tool

Assembly Instructions:

• Please see the Teensy 3.2 Breakout datasheet.