SparkFun RedBoard Qwiic

The SparkFun RedBoard Qwiic is an Arduino-compatible development board with Qwiic Connect System which means no soldering or shields are required to connect it to the rest of your system!

With the improved AP2112 voltage regulator, this Reboard gains a more robust 3.3V regulator that provides it more power to daisy chain multiple Qwiic boards and sensors, sourcing up to 600mA of current. To help support the micro USB connector (updated from a Mini USB), the CH340C Serial-USB converter IC allows the RedBoard Qwiic should reduce the need for you to manually install drivers allowing for newer operating systems to automatically recognize and install the drivers for the board. Lastly, a few solder jumpers have been added to the board. The jumpers for the A4 and A5 pins are tied directly to the I2C bus and can be used to disconnect the logic level converters from the pins while the voltage level jumpers can switch the RedBoard Qwiic from a 3.3V device to a 5V device (no logic level converter needed).

The SparkFun RedBoard Qwiic can be programmed over a USB Micro-B cable using the Arduino IDE: Just plug in the board, select ?Arduino UNO? from the board menu and you?re ready to upload code. RedBoard Qwiic has all of the hardware peripherals you know and love: 20 Digital I/O pins with 6 PWM pins, UART, SPI and external interrupts. You can power the SparkFun RedBoard Qwiic over USB or through the barrel jack. The on-board power regulator can handle anything from 7 to 15VDC.

Features:

• ATmega328 microcontroller with Optiboot (UNO) Bootloader
• CH340C Serial-USB Converter
• AP2112 Voltage Regulator
• A4/A5 Jumpers
• 3.3V to 5V Voltage Level Jumper
• Input voltage - 7-15V
• 1 Qwiic Connector
• 20 Digital I/O Pins (6 PWM Outputs and 6 Analog Inputs)
• ISP Header
• 32k Flash Memory
• 16MHz Clock Speed
• All SMD Construction
• R3 Shield Compatible
• Improved Reset Button