Der Artikel wurde erfolgreich hinzugefügt.
Der Artikel wurde erfolgreich hinzugefügt.

Adafruit Mono 2.5W Class D Audio Amplifier - PAM8302

Adafruit
Hersteller:
Adafruit
Artikel-Nr.:
EXP-R15-567
Herstellernummer:
2130
Verfügbarkeit:
15

Weitere Produktdaten ansehen

Auf Lager

Garantiertes Versanddatum: 19.09.18, wenn Sie in den nächsten bestellen

4,36 €*
Nettopreis: 3,66 €
Umsatzsteuer: 0,70 €
* Alle Preise inkl. gesetzl. Mehrwertsteuer zzgl. Versandkosten

This super small mono amplifier is surprisingly powerful - able to deliver up to 2.5 Watts into 4-8 ohm impedance speakers. Inside the miniature chip is a class D controller, able to run from 2.0V-5.5VDC. Since the amp is a class D, its very efficient (over 90% efficient when driving an 8Ω speaker at over half a Watt) - making it perfect for portable and battery-powered projects. It has built in thermal and over-current protection but we could barely tell it got hot. There's even a volume trim pot so you can adjust the volume on the board down from the default 24dB gain. This board is a welcome upgrade to basic "LM386" amps!

The A+ and A- inputs of the amplifier go through 1.0uF capacitors, so they are fully 'differential' - if you don't have differential outputs, simply tie the Audio- pin  to ground. The output is "Bridge Tied" - that means the output pins connect directly to the speaker pins, no connection to ground. The output is a high frequency 250KHz square wave PWM that is then 'averaged out' by the speaker coil - the high frequencies are not heard. All the above means that you can't connect the output into another amplifier, it should drive the speakers directly.

Comes with a fully assembled and tested breakout board. We also include header to plug it into a breadboard and a 3.5mm screw-terminal blocks so you can easily attach/detach your speaker. You will be ready to rock in 15 minutes! Speaker is not included, use any 4 ohm or greater impedance speaker.
  • Output Power: 2.5W at 4Ω, 10% THD, 1.5W at 8Ω, 10% THD, with 5.5V Supply
  • 50dB PSRR at 1KHz
  • Filterless design, with ferrite bead + capacitors on output.
  • Fixed 24dB gain, onboard trim potentiometer for adjusting input volume.
  • Thermal and short-circuit/over-current protection
  • Low current draw: 4mA quiescent and 1uA in shutdown mode

Technical Details:
Adafruit Audio FX Sound Board - WAV/OGG Trigger with 2MB Flash

21,40 €*

Nettopreis: 17,98 €
Umsatzsteuer: 3,42 €
* inkl. MwSt. zzgl. Versand
Adafruit Audio FX Mini Sound Board - WAV/OGG Trigger - 16MB Flash

23,06 €*

Nettopreis: 19,38 €
Umsatzsteuer: 3,68 €
* inkl. MwSt. zzgl. Versand
Adafruit Audio FX Mini Sound Board - WAV/OGG Trigger - 2MB Flash

16,01 €*

Nettopreis: 13,45 €
Umsatzsteuer: 2,56 €
* inkl. MwSt. zzgl. Versand
Adafruit I2S 3W Class D Amplifier Breakout - MAX98357A

6,45 €*

Nettopreis: 5,42 €
Umsatzsteuer: 1,03 €
* inkl. MwSt. zzgl. Versand
Adafruit Audio FX Sound Board - WAV/OGG Trigger with 2MB Flash

21,40 €*

Nettopreis: 17,98 €
Umsatzsteuer: 3,42 €
* inkl. MwSt. zzgl. Versand
Adafruit Audio FX Mini Sound Board - WAV/OGG Trigger - 16MB Flash

23,06 €*

Nettopreis: 19,38 €
Umsatzsteuer: 3,68 €
* inkl. MwSt. zzgl. Versand
Adafruit Audio FX Mini Sound Board - WAV/OGG Trigger - 2MB Flash

16,01 €*

Nettopreis: 13,45 €
Umsatzsteuer: 2,56 €
* inkl. MwSt. zzgl. Versand
Adafruit I2S 3W Class D Amplifier Breakout - MAX98357A

6,45 €*

Nettopreis: 5,42 €
Umsatzsteuer: 1,03 €
* inkl. MwSt. zzgl. Versand
Mini Metal Speaker w/ Wires - 8 ohm 0.5W

1,50 €*

Nettopreis: 1,26 €
Umsatzsteuer: 0,24 €
* inkl. MwSt. zzgl. Versand
Adafruit PowerBoost 1000 Charger - Rechargeable 5V Lipo USB Boost @ 1A - 1000C

19,46 €*

Nettopreis: 16,35 €
Umsatzsteuer: 3,11 €
* inkl. MwSt. zzgl. Versand
PiGRRL 2.0 Custom Gamepad PCB

4,95 €*

Nettopreis: 4,16 €
Umsatzsteuer: 0,79 €
* inkl. MwSt. zzgl. Versand
Breadboard-friendly SPDT Slide Switch

0,96 €*

Nettopreis: 0,81 €
Umsatzsteuer: 0,15 €
* inkl. MwSt. zzgl. Versand