Der Artikel wurde erfolgreich hinzugefügt.
Der Artikel wurde erfolgreich hinzugefügt.
Hersteller:
Sparkfun
Artikel-Nr.:
EXP-R05-071
Herstellernummer:
DEV-07914
Verfügbarkeit:
2

Weitere Produktdaten ansehen

Auf Lager

Garantiertes Versanddatum: 21.06.18, wenn Sie in den nächsten bestellen

11,15 €*
Riding on the waves of the very popular Arduino USB board is this small prototyping shield. Originally spawned with collaboration between the folks at SFE and ITP @ NYU, the ProtoShield mates with the Arduino USB board and gives the user a small soldering area, two general LEDs, access to a BlueSMiRF socket, a general pushbutton switch, and most important of all - the Arduino reset switch is brought to the top level. A ProtoShield quickstart guide (http://www.sparkfun.com/commerce/tutorial_info.php?tutorials_id=191) is available!
 
This comes in kit form and must be soldered together by the end user. Please note - we do not ship assembly instructions, but you can find a big, clean photographed assembly guide here(http://www.sparkfun.com/commerce/tutorial_info.php?tutorials_id=181)! There are a few tutorials on assembly listed below. All soldering is through-hole (relatively easy) but always check your component orientation before soldering!
 
Kit Includes:
  • 1x ProtoShield bare PCB
  • 2x Stackable Headers 6-pin
  • 2x Stackable Headers 8-pin
  • 2x 5mm Basic Yellow LEDs
  • 2x 330 Ohm resistors
  • 1x 10k resistor
  • 2x Momentary push buttons
  • 2x 0.1uF Ceramic Capacitors
 
Features:
  • All Arduino pins are brought to the top level
  • 5V, GND, and Vin pins are exposed as well
  • BlueSMiRF socket for wireless communication between Arduinos
  • 2 general use LEDs
  • 1 general use button
  • Reset button brought to top level
 
Documents: