Liebe Kunden,
wir haben von Samstag, den 23.12.17 bis einschließlich Montag, den 01.01.2018 Betriebsferien. Bestellungen in diesem Zeitraum werden erst wieder ab dem 02.01.2018 versendet. Bitte berücksichtigen Sie dies in Ihrer Bestellplanung.

Wir wünschen Ihnen geruhsame Feiertage und ein erfolgreiches Neues Jahr.

Der Artikel wurde erfolgreich hinzugefügt.
Der Artikel wurde erfolgreich hinzugefügt.
AKTION

Ab Warenkorbwert 50€ ein Aufkleber gratis!

Hersteller:
Pimoroni
Artikel-Nr.:
EXP-R40-009
Herstellernummer:
PIM013
Verfügbarkeit:
5

Weitere Produktdaten ansehen

Auf Lager

Garantiertes Versanddatum: 18.12.17, wenn Sie in den nächsten bestellen

9,95 €*
Get visual feedback from your Pi!

The PiGlow is a small add on board for the Raspberry Pi that provides 18 individually controllable LEDs. You can use it for all sorts of things! And of course, it fits inside a Pibow!

There are tons of things you can do with it:
  • Mood lighting / ambience
  • Showing current system load
  • Notify you of events like mentions in tweets or incoming e-mail
  • Feedback the status of scripts/daemons running on your Pi
  • Works great when VESA mounted to provide a cast against a wall
  • ...and pretty much anything else you can think of!


PiGlow sample code and other instructions:
If you just want some Python code to start tinkering with please check out our GitHub repository which also includes the full datasheet for the IC used on PiGlow.

Gordon Henderson has added a PiGlow driver for wiringPi which you can find here: http://wiringpi.com/dev-lib/piglow/

Simon Walters has added PiGlow support for Scratch which is here: http://cymplecy.wordpress.com/

Jason Barnett has put together a great Python class and a load of samples: https://github.com/Boeeerb/PiGlow

Ben Lebherz has forked Jasons project and tidied up the code a bit while adding gamma correction: https://github.com/benleb/PyGlow

More detail:
This board uses the SN3218 8-bit 18-channel PWM chip to drive 18 surface mount LEDs. Communication is done via I2C over the GPIO header with a bus address of 0x54 (Python example code provided). Each LED can be set to a PWM value of between 0 and 255.
  • 18 LEDs (three each of red, orange, yellow, green, blue, and white)
  • Great to provide feedback if you're running your Pi headless
  • PWM (dimming) control for each channel
  • Fully assembled (no soldering required)
  • Python code to access and control lighting provided
Raspberry Pi 3 Modell B - 1GB RAM

38,90 €*

Raspberry Pi 3 Modell B - 1GB RAM

38,90 €*