MIFARE® Classic 1K RFID/NFC Clear Tag 13.56MHz
3,15 € *
zzgl. MwSt. zzgl. Versandkosten
5 Stück sofort versandfertig
- Hersteller: Adafruit
- Artikel-Nr.: EXP-R15-584
- Herstellernummer: 361
- Herkunftsland: CN
- Zolltarifnummer: 85235200
- Gewicht (kg): 0.01
This is a blank MiFare Classic 'laundry' tag - often used for laundry or identification but... mehr
This is a blank MiFare Classic 'laundry' tag - often used for laundry or identification but also found in other systems where a small proximity card is desired. This one is clear! The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.
These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!
These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.
- S50 chip specification:
- 1 KiloByte (8 KiloBit) non-volatile EEPROM storage
- Built in encryption engine with 48-bit key
- 4 Byte unique identifier burned into the chip
- 13.56 MHz frequency
- Tag specification:
- 25.4mm diameter x 1mm
- 0.9 grams
- Works about 2" away from reader