Liebe Kunden,

vom 29.04.2020 bis einschließlich dem 05.05.2021 befinden wir uns in Betriebsferien. Bestellungen werden von uns noch bis zum 28.04.2021 und dann wieder ab dem 06.05.21 versendet.

Bitte beachten Sie dies bei Ihrer Bestellplanung.

Ihr EXP-Tech Team

MIFARE® Classic 1K (13.56MHz RFID/NFC) Charm - 1KB

3,00 € *

zzgl. MwSt. zzgl. Versandkosten

Sofort versandfertig, Lieferzeit ca. 1-3 Werktage

Bestellen Sie innerhalb der nächsten 14 Stunden und 19 Minuten damit die Bestellung morgen verschickt wird.
  • Adafruit
  • EXP-R15-581
  • 884
  • 5
  • CN
  • 85235200
  • 0.01
This is a blank MiFare Classic tag embedded in a phone charm. These tags are like those often... mehr

This is a blank MiFare Classic tag embedded in a phone charm. These tags are like those often used for train/bus passes but also found in other systems where a proximity card is desired. The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away. Since this tag has a small antenna, it has to be closer to the antenna than, say, a large credit-card sized tag.

These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!

These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.


Technical Details:

  • S50 chip specification:
    • 1 KiloByte (8 KiloBit) non-volatile EEPROM storage
    • Built in encryption engine with 48-bit key
    • 4 Byte unique identifier burned into the chip
    • 13.56 MHz frequency
  • Tag specification:
    • 39.82mm x 24.85mm x 4mm
    • loop is 140mm/5.5"
    • 4.5 grams with loop, 4 grams without
    • Works about 1" away from RFID reader
  • NXP S50 datasheet
Zuletzt angesehen